Famastil F-POWER P2111.120 Manual De Instrucciones página 30

ASSEMBLY AND OPERATING INSTRUCTIONS
SURFACE PREPARATION
Before starting any cleaning task, it is important to inspect the area for objects that
could create a hazard. Remove any objects from the work area that could be tripped
over, such as toys or outdoor furniture. Ensure that all doors and windows are closed
tightly.
WATER SUPPLY (COLD WATER ONLY)
Only draw water through the unit. For use with cold water supply only. Water hose
must be at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not
fall below 2 GPM (gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can
be determined by running the water for one minute into an empty 5-gallon (19 L)
container.
• Never use the pressure washer
to draw in water contaminated
with solvents (e.g. paint thinners,
gasoline, oil, etc.).
• Dirt in the water inlet will damage
the unit. To avoid this risk, we
recommend checking the water
filter (located inside the water inlet.
To clean it out see Maintenance
section).
• Always prevent debris from being
drawn into the unit by using a clean
water source and an additional
accessory water filter if required.
• To prolong the life of the unit, rest
the unit for 5 minutes after every 30
minutes of use.
30
CAUTION
1
Attach high pressure hose to the machine's
water outlet (hand tighten only).
WARNING! With the water inlet
hose already connected, but before
turning on your washing machine,
release the water flow in the tap and
hold the trigger down. This will serve
to remove the false air contained
within the hose and pump. It is
advisable to keep the trigger pressed
1 to 2 minutes to remove all air.