Radio Installation; Installing And Removing The Control Head - Tait TM81 Serie Guía Del Usario

The following topics are covered in this section:

Installing and removing the control head

Caution:
Installing the control head on the radio body
Note: The way in which the U-bracket is mounted deter-
The numbers in the diagram on the following page refer to
the numbered steps below.
1
2

Radio installation

installing and removing the control head
installing the microphone
installing the antenna
installing the power cable
mounting the U-bracket
installing the radio in the U-bracket
TM8105 programming connector
checking the installation
other installation
The control head contains devices which can be
damaged by static discharges. Always install or
remove the control head in a static-
safe environment.
Website: For information on antistatic precautions,
go to the Electrostatic Discharge Association (ESD)
website, http://www.esda.org.
mines which way up the control head is mounted on
the radio body.
Plug the control head loom onto the control
head connector.
Insert the bottom edge of the control head onto the
two clips in the front of the radio chassis, then snap
into place.
options.
Radio installation 31