Installing The Radio In The U-Bracket; Tm8105 Programming Connector - Tait TM81 Serie Guía Del Usario

Installing the radio in the U-bracket

1
2
3
4

TM8105 programming connector

The TM8105 has a 9-way D-range plug on the control head,
for remote connection. The pin allocations of the programming
connector are shown in the following diagram and table.
38 Radio installation
Connect the antenna and power cables to the rear of
the radio.
Position the radio in the U-bracket so that the holes in the
U-bracket line up with the holes in the radio chassis.
Screw the radio into position using the four thumb screws
but without fully tightening the screws.
Position the radio in the U-bracket for best viewing angle,
then tighten the thumb screws.
programming
connector