Operating Messages; Error Codes - Tintometer Lovibond MD 100 Manual De Instrucciones

Operating messages – Error codes
GB
Hı
Lo
btLo
Store Date
Print Time
Cal
RESULT
E27 / E28 / E29
E 10 / E 11
E 20 /E 21
E23 / E24 / E25
E 22
E 70
E 71
E 72
E 73
MD100_8 07/2016

Operating messages

Measuring range exceeded or excessive turbidity.
Result below the lowest limit of the measuring range.
Replace batteries, no further tests possible.
Battery capacity is too low for the display backlight;
measurement is still possible.
A user calibrated method is indicated by a "Cal" symbol while the test
result is displayed. (see "Factory calibration reset").

Error codes

Light absorption too great. Reasons: e.g. dirty optics.
Calibration factor "out of range"
Too much light reaching the detector.
Too much light reaching the detector.
Battery capacity was too low during measurement. Change battery.
CLO tablet: Factory calibration incorrect / erased
2
CLO tablet: User calibration incorrect / erased
2
CLO powder: Factory calibration incorrect / erased
2
CLO powder: User calibration incorrect / erased
2
35