Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
Safety of others
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by
a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Symbols on the charging base
Your charging base is double insulated; therefore
no earth wire is required.
Fail-safe isolating transformer. The mains supply is
electrically separated from the transformer output.
130
o
C
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
The charging base is intended for indoor use only.
Surfaces may become hot during use and during
the cool down period.
Features
1. Release latch for container door
2. Container door
3. Collector lock button
4. Two-speed on/off switch
5. Filter cleaning wheel
6. Charging indicator
7. Charging base
8. Dust collector extension
9. Dust collector
Fig. D
10. Crevice tool (optional, see packaging)
11. Brush tool (stored in underside of appliance)
8
Installation
Fitting the charging base to the wall (fig. A)
The charging base can be placed on a work top or fitted to
the wall to provide a convenient storage and charging point
for the appliance.
When fixing to a wall, make sure that the fixing method is
suitable for the wall type and is appropriate to the weight
of the appliance.
Assembly
Adjusting the dust collector (fig. B & C)
The dust collector (9) is stored under the appliance. To
adjust for use, lift the appliance from the charging base.
Press the collector lock button (3) and rotate the dust
collector to the required position.
Release the collector lock button to lock the dust
collector in position.
The dust collector can be extended by pulling the dust
collector extension (8) until it locks into position.
The extension can be retracted by pressing the
button (13) and pushing the extension back into the
dust collector.
The dust collector should be returned to the storage
position under the appliance after use and while
charging the appliance.
Fitting the accessories (fig. D)
These models are supplied with some or all of the following
accessories:
A crevice tool (10) for confined spaces.
A brush tool (11) for furniture and stairs.
To fit an accessory, proceed as follows:
Take the accessories from the appliance.
Insert the appropriate accessory into the front of the
appliance.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
Injuries caused by touching any rotating/moving parts.
Injuries caused when changing any parts, blades or
accessories.
Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods make sure you take
regular breaks.
Impairment of hearing.
Publicidad
Tabla de contenido
