Kidde 0976 Guia Del Usuario página 5

Alarmas contra humo a batería de 9 voltios de carga delantera con control hush, que permite silenciar temporalmente alarmas molestas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• In insect-infested areas.
• Smoke alarms should not be installed within 3 ft (.9m) of the following: the
door to a kitchen, the door to a bathroom containing a tub or shower, forced
air supply ducts used for heating or cooling, ceiling or whole house ventilating
fans, or other high air flow areas.
• Kitchens. Normal cooking may cause nuisance alarms. If a kitchen alarm is
desired, it should have an alarm silence feature or be a photoelectric type.
• Near fluorescent lights. Electronic "noise" may cause nuisance alarms.
• Smoke alarms are not to be used with detector guards unless the combination
(alarm and guard) has been evaluated and found suitable for that purpose.
3. INSTALLATION INSTRUCTIONS
MOUNTING INSTRUCTIONS
CAUTION: THIS UNIT IS SEALED. THE COVER IS NOT REMOVABLE!
CAUTION: WHEN WALL MOUNTING: UNIT MUST BE MOUNTED SO
THAT THE BATTERY BOX FACES DOWN! (SEE FIGURE 4). INCORRECT
ORIENTATION OF WALL MOUNTED SMOKE ALARMS WILL DECREASE
OPERATIONAL EFFECTIVENESS.
1. Remove the mounting plate from the back of the alarm by holding the
mounting plate and twisting in the direction indicated by the "OFF" arrow on
the alarm cover.
2. After selecting the proper smoke alarm location as described in section 1,
attach the mounting plate as shown in figure 5. Use the screws and anchors
provided to secure the mounting plate (use 3/16" drill bit
for anchor holes). To ensure aesthetic alignment of the
alarm with the hallway or wall, the "A" line on the
mounting bracket should be parallel with the hallway
when ceiling mounted, or horizontal when wall mounted.
3. Make sure that the mounting screws are positioned in
the small ends of the keyholes before tightening the
screws.
4. Install the alarm on the mounting plate and rotate the
alarm in the direction indicated by the "ON" arrow on the cover until the alarm
ratchets into place (this ratcheting function allows for aesthetic alignment).
NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).
When wall mounting, make sure the battery box is at the bottom of the unit
(see figure 5).
FIGURE 4

Publicidad

Tabla de contenido
loading

Tabla de contenido