Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL
Failure
There is no power
in the equipment
N o d i s p l a y o r
temperature error
Speed is not
shown or there is
no rotation
Abnormal noise
Pressure leakage
and low vacuum
degree
J
.P. SELECTA s.a.u.
CODE 80359 REV 0
11. Problems & Troubleshooting
No electricity supply
Fusion of protective tube
Switch power supply failure
Circuit board failure
Display panel failure
The display panel cables fall
Short circuit or open sensor
circuit
Engine failure
Circuit board failure
Slow-running rotary switch out
of service
Speed control key out of service Replace the speed control knob
Insensitive rotation of the stirring
blades
Engine failure
Debris inside the container
Glasses installed and mounted
with holes
Abrasion of the sealing ring
Improper installation of the
sealing gasket
Aging of the vacuum hose
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: www.grupo-selecta.com
May 2019
(It can be modified without notice)
Cause
Check the power source
Change the protective tube
Change the switch
Contact SAT
Replace the display panel
Fix the connection cables
Check if the seals have loosened:
if loose, re-weld. If not, you must
replace the sensor
Contact SAT
Replace the slow-motion switch
Reassemble
Contact SAT
Check and clean them
Reassemble
Replace the sealing gasket
Reassemble the gasket
Replace the vacuum hose
Page: 43
Troubleshooting
Tel 34 937 700 877 Fax 34 937 702 362
Publicidad
Tabla de contenido
