Menu Installation; Automatic Search; Manual Search - IOTRONIC 7128 Manual De Instrucciones

9.- Menu Installation

9.1.- Automatic search

Select this mode to carry out an automatic search over the whole receiver
input band.
In the option "Search Mode", select one of the two options, "Free" (Only
the open channels) or "All" (All channels).
Locate the cursor on the "Search" option and press the O O K K button on the
remote control.
The complete search can take a few minutes.
If you wish to interrupt the search, press the M M E E N N U U or E E X X I I T T buttons.

9.2.- Manual search

Select this mode to carry out a search for a given channel or frequency.
In the option "Scan Mode", select one of the two search options, "by
channel" or "by frequency" using the V V O O L L /V V O O L L
In the option "Scan Band", select one of the two options for carrying out
the search: "UHF" or "VHF", using the V V O O L L /V V O O L L
In the option "Ch No", select the channel where the search will be made.
The channels vary according to the band selected. Select a channel using
the V V O O L L /V V O O L L buttons, or else press O O K K to enable an merging menu,
select the channel with the C C H H
If you are carrying out a search by frequency, enter the channel frequency
in the "Frequency" option, and the value corresponding to that frequency
in the "BandWidth" option. To enter the frequency, click the O O K K button on
this option. A cursor will be shown positioned over the first digit to show
that it may be modified by using the C C H H
/V V O O L L
buttons will allow you to select another digit. You can also enter
the frequency by using the numerical (0 ... 9) keyboard. Press the O O K K
button again to make the setting.
Check whether the channel or frequency you selected corresponds to a
digital channel. This will be easily seen if the quality bar at the bottom of
the screen shows an acceptable quality percentage.
In the "BandWidth" option, you can choose among 6, 7 or 8 MHz, using
the V V O O L L /V V O O L L buttons. .
Finally, place the cursor on the "Search" option and press the O O K K button
on the remote control.
You can continue the search process by using the indicators shown on the
TV screen.
If you wish to interrupt the search, press the M M E E N N U U or E E X X I I T T buttons.
All manuals and user guides at all-guides.com
buttons.
buttons.
/C C H H buttons, and select O O K K to confirm.
/C C H H buttons. The V V O O L L
User manual
50