RDI METAL WORKS Excalibur Instrucciones De Instalación página 4

STAIR RAIL INSTRUCTIONS
1.
Place a plank on the stair noses
spanning from post to post. Place the
stair panel on the plank across the
opening and adjust for plumb ensuring
equal baluster spacing at each end.
Clamp the panel in place at this location
(Fig. 13).
Note: Use the proper plank thickness
to ensure the proper finished rail height.
Check local building codes for stair rail
height requirements.
2.
Assemble a stair mounting bracket. Hold
the bracket (angled end) against the post
face and in line with your stair panel,
mark the rail at these locations. Repeat
this for all 4 rail ends. Be sure to label the
top end of the top rail before removing it
(Fig. 14).
(Fig. 13)
3.
Add 7/8" (toward rail end or post) to the
marks made on the rail panel in step 2
(Fig. 15) and cut panel at these marks
(Fig. 16).
Insert the cut panel ends into the stair
brackets ensuring all are properly
oriented. Test the panel to ensure proper
fit. Mark the position of the bracket on all
4 posts (Fig. 17).
Once proper fit is ensured remove the
brackets from the rail panel and paint all
cuts (Fig. 18).
(Fig. 14)
4
(Fig. 15)
7/8"
(Fig. 16)