RDI METAL WORKS Excalibur Instrucciones De Instalación página 5

STAIR RAIL INSTRUCTIONS
4.
Insert the cut panel ends into the stair
brackets ensuring all are properly
oriented. Test the panel to ensure proper
fit. Mark the position of the bracket on all
4 posts (Fig. 17).
Once proper fit is ensured remove the
brackets from the rail panel and paint all
cuts (Fig. 18).
Reinsert the painted panel ends into the
brackets and secure in place (Fig. 19)
using the supplied self-tapping panel
attachment screws through the pre-
drilled bracket holes.
5.
Separate the two bracket halves at all
rail ends. Install the post half of each
mounting bracket at the marks made
in step 3 (Fig. 20) ensuring all brackets
are properly oriented. Now set the
panel back into place and re-attach the
bracket halves (Fig. 21).
(Fig. 17)
(Fig. 18)
(Fig. 19)
6.
Assemble the 2 piece post trim cover by
inserting one fastener in each trim half
(Fig. 22). Snap these in place (Fig. 23)
concealing the post flange.
(Fig. 20)
(Fig. 21)
5
(Fig. 22)
(Fig. 23)