GE GFMN110 Instrucciones De Instalación página 6

BATHROOM OR BEDROOM INSTALLATION
7
MOBILE OR MANUFACTURED HOME
8
INSTALLATION
GARAGE INSTALLATION (IF ALLOWED
9
BY LOCAL CODES)
10 DRYER EXHAUST TO RIGHT, LEFT OR
BOTTOM CABINET
WARNING -
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES.
REMOVE
SCREW
AND SAVE.
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
Installation Instructions
BEFORE PERFORMING
REMOVE DESIRED
KNOCKOUT (ONE ONLY).
B
Cut the duct as shown and keep portion A.
TAB LOCATION
BEND TAB
o
UP 45
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
RIGHT OR
LEFT SIDE
EXHAUST
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previousl to secure
the duct in place through the tab on the appliance base.
FIXING HOLE
A
9"