Warnings And Limitations - INIM Electronics enea EM411R Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

The module must be connected to the control panel via a 2 pole twisted-

shielded cable. This cable carries both the power supply and the two-way digital

communications data. Refer to the Installation section for the wiring diagram.

The module has a short-circuit isolator which, in the event of short-circuit

between the two poles of the control panel loop cable, is capable of

interrupting the negative pole and thus isolating the section involved in the

short-circuit. For the isolator specification, please refer to the "ILP

Specification" document.

The module should be housed inside an electrical mounting box, as per the

diagram, with the following characteristics:

• Minimal internal dimensions: 100 x 60 x 40 mm

• Protection grade IP44 or higher

• Compliant with the established standards and codes relating to the Installation of

electrical systems

The two removable serial number stickers should be taken off

the module; one should be attached to the box where the

device is to be housed, the other to the installation layout.

Once all the loop devices have been properly connected, refer to the control

panel installation and programming manual for instructions regarding the

configuration and addressing procedures.

The functionality of the module should be tested immediately after installation and periodically during

maintenance inspections, in accordance with the established standard regulations and codes in force.

The EITK-DRV driver allows you to change the operating parameters of the devices connected to the loop and

also to obtain accurate diagnostic data. It can operate through the USB port of a computer furnished with the

relative software programme, or can function autonomously by way of the battery housed inside.

For further information and details regarding use of the EITK-DRV driver, refer to the respective handbook.

The EM411R module must be used exclusively with control panels that operate on INIM OpenLoop protocol. This

product is not suitable for outdoor installation. However, if outdoor installation is necessary, ensure that the

device is housed inside a suitable enclosure with the required protection grade.

INIM Electronics reserves the right to change

the technical specifications of this product

without prior notice.

NO1 NC1 C1

NO2 NC2 C2

Installation

Testing and maintenance

Using the EITK-DRV driver