INNO TR149 Instrucciones De Instalación página 4

４N・ｍ
Hex Wrench
Convex
Base Unit
Base Cover
Installing System Carrier
Bolts[M6X15]
15mm 15mm
Base Unit
1
Place the base unit on the installed
cushion base/base bracket. Then using
the Hex wrench (included), tighten while
alternating between the right and left
bolts (short) [M6x15] ( supplied with
the carrier ) until the bolts are firmly
tightened.
Place the base unit in a way that the
convex section is on the inner side of the
vehicle.
After removing the stay and the bar,
leaving only the base unit on the vehicle,
apply the base cover to the base unit.
EN-４
EN
-EN
4182809TR1494 -A