Connecting The Drain Hose; Connect To The Power Supply - Kenmore 796.4044#9 Serie Manual De Uso Y Cuidado

CONNECTING THE DRAIN HOSE
•The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
flooding and property damage.
• Do not install the end of the drain hose higher than 96 in.
(244.8 cm) above the bottom of the washer.
•The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
NOTE:
A drain hose extension kit is
available if the drain hose is not
long enough. Do not extend
drain hose more that 6 feet, as
this will cause poor draining
resulting in poor wash and spin
performance.
f _Drain Hose Extension 1
(_ P/N 5215ER2002K
Option 1" Standpipe
f
Elbow Bracket
Drain Hose
The elbow bracket should be installed near the end of the
drain hose. Insert the end of the drain hose into the
standpipe. Use tie strap to secure the drain hose in place.
NOTE:
•Total height of the hose end should not exceed 96 in.
(244.8 cm) from the bottom of the washer.
•The drain hose should be inserted no more than 8-12
inches into the standpipe.
NOTE: If the drain hose is extended more than 4 inches
beyond the end of the end of the elbow bracket, mold, or
microorganisms could spread to the inside of the washer.
Option 2: Laundry Tub
Ilii
Elbow Bracket
Tie Strap
Drain Hose
The elbow bracket should be installed near the end of the
drain hose. Hang the end of the drain hose over the side of
the laundry tub. Use tie strap to secure the drain hose in
place.
Option 3: Floor Drain
f
Drain Hose
Floor Drain
-_ IIII
Insert the end of the drain hose into the floor drain.
Secure the hose to prevent it from moving.
CONNECT TO THE POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz.
grounded 3-prong outlet.
Plug in the washer.
_ J
10