Gardenline 22096-20 Manual Del Usuario página 5

CC
H
H
Fig. 1
FF
B
CC
Fig. 2
STEP 1:
Bring two Crossbeams (B) together so their open ends meet. Insert
four Bolts M6x35mm (CC) through Connector (H), through Crossbeams
(B), and through a second Connector (H), tighten down using M6 Nut
(FF); see Figure 1. The head of the Bolts M6x35mm (CC) should be on the
same side of the Crossbeams (B) that the Canopy Guide Bar (F) will be
placed on; see next step below.
Place Canopy Guide Bar (F) against the assembled Crossbeams (B).
Insert two Bolts M6x35mm (CC) through Crossbeams (B) and into Canopy
Guide Bar (F), tightened down to hold parts together.
Repeat these steps for the second set of Crossbeams (B).
8
support@tdcusainc.com
MODEL: 22096-20 PRODUCT CODE: 44964
Assembly Instructions
B
2X
F
B
CC FF
(12) M6X35 mm Screw (8) M6 Nut
AFTER SALES SUPPORT
1800 599 8898
USA
04/2020
USA
B
Fig. 3
L
STEP 2:
Insert Crossbeam (C) into Crossbeam (D). Insert two Bolts M6x10mm
(AA) through Crossbeam (D) and into Crossbeam (C), tightened down
to hold parts together; see Figure 3.
Insert two Bolts M6x15mm (BB) through Plate (L) and into bottoms
of Crossbeam (C) and Crossbeam (D), tightened down to hold parts
together; see Figure 3.
Repeat these steps for the second set of Crossbeams (C & D).
AFTER SALES SUPPORT
1800 599 8898
USA
MODEL: 22096-20 PRODUCT CODE: 44964
C
AA
BB
C
AA
(4) M6X10 mm Screw
04/2020
USA
Assembly Instructions
D
2X
D
BB
(4) M6X15 mm Screw
9
support@tdcusainc.com