Safety; System Installation; Initial Start-Up & Seasonal Operation - Airmax Shallow Water Serie El Manual Del Propietario

2. Safety

SAFETY
• Read all operating instructions carefully.
• To reduce the risk of electric shock, connect only to a properly grounded, grounding-type receptacle.
If in doubt, have the outlet checked by a qualified electrician.
• This unit is to be used in a circuit protected by a ground fault circuit interrupter (GFCI).
• Disconnect unit from power source before handling or maintenance.
• Repair or exchange of cable/power cord must be carried through by the supplier/manufacturer.
• This unit has not been investigated for use in swimming pool areas.
CAUTION
• Never connect to an extension cord. This may result in equipment failure.
• Do not allow anything to rest on the power cord.
• Do not place the cabinet where people may step on the power cord.
• Never override or "cheat" electrical or mechanical interlock devices.
• Never attempt any maintenance function that is not specified in the user manual.
• Never operate the system if unusual noises or odors are detected. Disconnect the power cord from
the outlet and call for service.
GROUNDING INSTRUCTIONS
This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded in accordance with all local codes and ordinances.

3. System Installation

For quick, easy and professional installations, it is suggested that the following materials be
on-site: (None of the following are included with the Airmax
• Placement Rope
• Level
• Coast Guard-approved life jacket
• Shovel
• Flathead screwdriver
Location
• Locate cabinet on a solid support with adequate strength for weight of unit.
• Locate cabinet away from irrigation sprinklers.
• Wear a Coast Guard-approved life jacket; follow all safety and caution guidelines.
WARNING: All compressor cabinets must be located above the water level.
Option A
Pond's Edge
Option A: When power source is available at pond's edge, simply connect one end of EasySet
to flex-hose and other end to diffuser plate. Steps 2 & 3 below are not necessary using this option.
Option B: When power source is not available at pond's edge, place SilentAir
nearest power source. Trench Direct Burial Airline (sold separately, ½" standard irrigation pipe may be
substituted) from flex-tube to pond's edge; then connect to EasySet
Each diffuser will be a separate run of airline. Each run may not exceed several hundred feet.
4. Initial Start-Up & Seasonal Operation
The circulation of poor quality, low oxygen, deep water to the pond's surface can introduce harmful gases
and by-products into the previously healthy upper regions of the water column. These by-products can
make the upper regions unfit for aquatic life and could result in fish-kill.
Initial Start-Up Procedure To Prevent Fish-Kill:
Follow this procedure anytime system has been shut-off for an extended period of time.
Day 1: Run system for 30 minutes; turn system off for remainder of day.
Day 2: Run system for 1 hour; turn system off for remainder of day.
Day 3: Run system for 2 hours; turn system off for remainder of day.
Day 4: Run system for 4 hours; turn system off for remainder of day.
Day 5: Run system for 8 hours; turn system off for remainder of day.
Day 6: Run system for 16 hours; turn system off for remainder of day.
Day 7: Begin running system 24 hours/day, 7 days/week.
Summer Operation
To reduce the risk of fish kills in hot summer months and for optimum aeration benefits,
Airmax ® Aeration Systems should run continuously throughout the summer. To enhance pond health,
reduce mucky bottoms and enhance pond's aesthetic appeal, try Pond Logic
MuckAway ™ PondClear
Ma Pc
4
® Aeration System)
• Utility razor knife
• Boat/Raft/Swimsuit
• Small stone or gravel
• Rake
• Permanent Marker
Away from
Pond's Edge
™
™ Airline and run to diffuser plate.
® products:
™ EcoBoost ™ Pond Dye
Eb Nb Bk Tw
WARNING – Improper installation of the grounding plug is able to result in a risk of electric shock.
When repair or replacement of the cord or plug is required, do not connect the grounding wire to either
flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow
stripes is the grounding wire.
For 120 VAC products:
This product is for use on a nominal 120V circuit, and has a grounding plug similar to the plug
illustrated in sketch A in Figure below. A temporary adapter similar to the adapter illustrated in sketches
B and C may be used to connect this plug to a 2-pole receptacle as shown in sketch B when a properly
grounded outlet is not available. The temporary adapter shall be used only until a properly grounded
outlet (sketch A) is installed by a qualified electrician. The green colored rigid ear, lug, or similar part
extending from the adapter must be connected to a permanent ground such as a properly grounded
outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw.
1
Decide on a location for the cabinet and prep
ground. May be placed several hundred feet from
shoreline (using direct burial airline) if power is not
available at shore.
3
Option B
Option B Only:
™
EasySet
5
™ Airline
Cabinet next to
Connect diffuser to airline. Extend EasySet
weighted airline to proper location. Place diffuser.
To ensure proper placement, use nylon rope. Plates
should be located towards the deepest part of the
pond with a maximum depth of 6'.
Winter Operation
Owner assumes all responsibility for operating Airmax
Operating in freezing conditions on an ice-covered pond will cause large open water areas at diffuser
sites. Ice thickness around open areas will be much thinner than the surrounding areas. Airmax
strongly recommends that "Danger - Thin Ice" be posted at frequent intervals around pond.
If you choose to turn your system off for the winter, do the following:
• Unplug your aeration system.
• Disconnect compressor flex-tube(s) from airline(s).
• Cover airline ends with the included winterization caps to prevent debris from entering airline.
• Move cabinet and compressor inside to keep dry.
• If operating during the winter season, condensation could cause airlines to freeze. If so:
• Use 1 cup isopropyl alcohol in the airline running out to each plate.
• Turn on compressor to push through line and free any ice blockage.
2
Option B Only:
8" of depth for direct burial line. Place and backfill all
direct burial airline (one line per diffuser).
4
Connect direct burial airline to
Connect airline to flex lines supplied with cabinet.
self-weighted airline.
Open cabinet, plug compressor and cooling fan into
power control. Plug power control cord into power
outlet. Flip power switch to the ON position.
6
self-
Bubbles should be noticeable from all diffuser
™
locations. When more than one diffuser is installed,
adjust valves for maximum performance. Once
adjustments are made, wait several minutes to see
results at the diffuser location(s). Deeper placement of
plate(s) and longer runs of tube will require more flow.
® Aeration System during winter months.
ENGLISH
Excavate trench to a minimum of
®