Instruction Manual - ratiotec Soldi 120 Instrucciones De Uso

Technical data
Voltage supply
Dimensions
Weight
Operation
Plug the device into a power socket.
Select UV or white light detection
using the switch on the right-hand
side of the device.
Attention:
Switch device off and unplug from power supply before changing light sources .
Replacing the UV-light
Remove the three screws from the
underside of the device. Separate
the top and bottom sections. Remo-
ve the UV-light source and replace it
1
2
Please note that the UV light bulbs are consumable supplies. Their daily deterioration is not covered
by our guarantee.
230V / 50Hz
185 x 85 x 79 mm
0,4 Kg
O = Off
I = UV light
with a new one with the same technical specification. Ca-
refully reassemble the top and bottom sections and tighten
the screws.
3
4
7