HumanTechnik Signolux Manual De Instrucciones página 6

b) Now it should be possible to unhook the front from the
the other side of the housing for removal.
c) You can now open the small screw (fig. 1 B) using a small
Phillips screwdriver and remove the front of the call-push-
button behind which the PCB with the battery. is located.
d) Insert the battery (coin cell CR 2032) into the plastic
support on the PCB (fig. 2 D).
D
E
Figure 2: Battery compartment
e) If you would like to replace a battery, remove the old
one with a small flat screwdriver from its plastic support
by lifting the edge slightly (fig. 2 E). Afterwards you can
insert a new battery. Kindly ensure correct polarity of
the battery.
f) Insert the front face into the housing of the call-push-
button and press both firmly together until the housing
parts lock in place. Please make sure that the rubber
gasket sits correctly within the housing.
g) Carefully set the small screw (fig. 1 B) with a small
Phillips screwdriver.
English 5
h) Hook the plastic front onto the clip of one side, then
press the other side down until the front completely
locks onto the housing.
2. Do not forget to register your call-pushbutton with
your »signolux«-receivers!
a) Keep the function button of the according receiver pressed.
The symbols light up in sequence. Release the button
when the desired symbol is lit.
b) Press the call-pushbutton.
c) Wait for approx. 20 seconds and test the function.
3. Mounting the call-pushbutton
You can mount the call-pushbutton, if needed, by using the
supplied strip of double-sided tape. Take care to adhere
it to a smooth, dry and clean surface.
Important note:
Kindly keep in mind that metal parts and other building
materials may interfere with the transmission of the radio
signal. As they can be either visible or hidden at the
desired mounting location you should always carry out
a functional test at the mounting location before starting
the mounting process, and, if required, choose a different
mounting or installation location if the reception is not
guaranteed.