Safety Devices; Warranty Conditions - SHIDO DC4.0 Instrucciones

BATTERY TESTS AND ERROR INDICATORS
In cause of faults, the battery tester will display the following indications:
DISPLAY INDICATION CAUSE

SAFETY DEVICES

The battery chargers are equipped with safety devices to ensure the utmost safety during use and operation.
• Full protection against sparks
• Protection against short-circuits
• Voltage compensation
• Protection against overheating
• Protection against polarity reversal
• High protection rating against external agents, IP65
MAINTENANCE
When the battery charger is not being used, it must be stored in a dry place to protect it against humidity. Disconnect
the battery charger and use a soft cloth to clean its outer casing.

WARRANTY CONDITIONS

1. This product is warranted by the manufacturer for a period of 24 months from date of purchase, as stated on the
proof of purchase from the dealer.
2. The warranty provides for free repair or replacement of any parts in case of manufacturing and material defects
acknowledged by the manufacturer.
3. Any problems arising from negligence, misuse or tampering with the appliance will void the warranty.
4. The warranty will only be valid if the appliance is repaired by trained personnel authorised by the manufacturer.
5. Incorrect connection to the mains, differences between the power supply voltage and the plate rated voltage of the
battery charger, and line voltage fluctuations caused, for example, by external agents and lightning strikes, will
invalidate the warranty.
6. The warranty certificate must be accompanied by either a valid purchase receipt or a bill of parcel.
7. No liability can be accepted for direct or consequential damages to persons or things of any kind howsoever
arising in connection with the use of battery charger.
The clamps of the output leads are not
connected correctly to the battery.
Polarity reversal.
Battery voltage too
attempting to charge a 24V battery).
Battery capacity excessive.
Battery cannot maintain a good level of
charge.
Battery flat.
Leads disconnected, leads short-circuited.
Battery completely short-circuited.
SOLUTION
Position the clamps correctly and start
charging the battery again (see section
"Operating the battery charger").
high. (You are Check the battery voltage.
Use battery charger with greater charging
capacity.
The battery may be defective. Contact your
nearest battery service centre.
Press the button again, to restart charging,
and try to recover the battery.
Position the clamps correctly and start
charging the battery again (see section
"Operating the battery charger").
The battery may be defective. Contact your
nearest battery service centre.