Publicidad
Idiomas disponibles
Idiomas disponibles
HE150 6P
HEADLAMP
Battery Warning (For headlamp)
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(Ni-Cd, Ni-MH, etc.) batteries.
IMPORTANT NOTICE:
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: 1) This device may
not cause harmful interference, and 2) this device must accept
any interference received,including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Safety Information For microTALK
Radios
®
Your wireless handheld portable transceiver contains a low
power transmitter. When the Talk button is pushed, it sends out
radio frequency (RF) signals. The device is authorized to
operate at a duty factor not to exceed 50%. In August 1996, the
Federal Communications Commissions (FCC) adopted RF
exposure guidelines with safety levels for handheld wireless
devices.
Important:
FCC RF Exposure Requirements: For body-worn operation, this
radio has been tested and meets the FCC RF exposure
guidelines when used with Cobra accessories supplied or
designated for this product. Use of other accessories may not
ensure compliance with FCC RF exposure guidelines. Use only
the supplied antenna. Unauthorized antennas, modifications, or
attachments could damage the transmitter and may violate
FCC regulations.
Normal Position:
Hold the transmitter approximately two (2) inches from your
face and speak in a normal voice, with the antenna pointed up
and away.
High / Low / Strobe Button
Press the High / Low / Strobe button to cycle through lighting modes as follow:
HIGH LOW FLASHING OFF
Battery Installation (Headlamp)
1. Open battery case cover.
2. Insert 3 x AAA alkaline batteries and position batteries according to the
polarity markings.
3. Close battery case cover.
FCC Part 15.21 Warning Statement-
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED
BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH
MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
IC RSS-GEN
This device complies with ISED license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference
that may cause undesired operation of the device.
Under ISED regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by ISED. To reduce potential radio
interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful
communication.
The applicant is responsible for providing proper instructions to
the user of the radio device, and any usage restrictions,
including limits of exposure durations. The user manual shall
provide installation and operation instructions, as well as any
special usage conditions, to ensure compliance with SAR
and/or RF field strength limits. For instance, compliance
distance shall be clearly stated in the user manual.
Radiation Exposure Statement:
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
For Remote controller, SAR tests are conducted using standard
operating positions accepted by the FCC/ISED with the device
transmitting at its highest certified power level in all tested
frequency bands, although the SAR is determined at the
highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value.
Before a new model device is available for sale to the public, it
must be tested and certified to the FCC that it does not exceed
the exposure limit established by the FCC/ISED, Tests for each
device are performed in positions and locations (e.g. at the ear
and worn on the body) as required by the FCC/ISED.
For body worn operation, this model device has been tested
and meets the FCC/ISED RF exposure guidelines when used
with an accessory designated for this product or when used
with an accessory that Contains no metal and that positions the
handset a minimum of 10 mm from the body.
Non-compliance with the above restrictions may result in
violation of RF exposure guidelines.
User's Guide
AA A
AAA
AA A
Negative contact battery spring
Product Service and Support
For any questions about operating this new Cobra branded
product, PLEASE CONTACT US FIRST... do not return this
product to the retail store. The contact information for support
will vary depending on the country in which you purchased and
utilize the product.
To obtain warranty service or other information for products
purchased from Altis itself or through its authorized reseller or
agent and utilized in the U.S.A., please call our consumer
support line at (866) 721-3805, or email us at
support@altistec.com. You will receive instructions on how to
ship the products at your expense to an Altis Global Limited
Authorized Service Center. To obtain service, you must include:
(a) a copy of your receipt, bill of sale or other comparable proof
of purchase; (b) a written description of the problem; and, most
importantly; (c) your address and telephone number.
For warranty and customer service information outside the US,
please contact your local dealer.
For further information needed on its features, please visit
www.cobrawalkietalkie.com for frequently asked questions and
the electronic manual.
Trademark Acknowledgment
Manufactured, distributed, or sold by Altis Global Limited,
official licensee for this product. Cobra
, microTalk
®
Comes Close to a Cobra
, and the snake design are registered
®
trademarks of Cobra Electronics Corporation, USA. Cobra
Electronics Corporation™ is a trademark of Cobra Electronics
Corporation, USA. All other product or service names are the
property of their respective owners.
©Cobra Electronics Corporation, USA 2019. All rights reserved.
WARNING - CHOCKING HAZARD - SMALL PARTS
Not for children under 3 years old. This product is
not intended to be used as a toy or plaything.
, Nothing
®
Publicidad
