ASSEMBLY
1. Attach Hydraulic Unit to receiver platform and secure
with provided bolts.
2. Insert the Bottle Jack Ram Pin to connect the Bottle
Jack to the cross head (If holes do not line up, twist
the Bottle Jack Ram until they are aligned).
3. Install Lift Pedal into Sleeve.
4. Install spring around the middle bolt on the frame and
the Height Unlocking Handle.
5. Install rear handle into frame and secure using the
provided pin.
6. Install Wheel Brackets using hardware provided.
7. After assembly, ensure lift rolls freely, lifts, locks and
lowers easily, and that Bottle Jack operates smoothly
before putting into service. Familiarize yourself with
operation of Height Locking Lever and Lift Pedal.
Oil Filler Plug
Hydraulic Unit
Hyd Unit
Hardware
Automatic Locking
Middle Frame
Bolt
Lift Pedal
Release Valve
Ram Connecting Pin
Spring
Figure 1 - Utility Lift Nomenclature
WARNING
!
• Study, understand and follow all instructions
before operating this device.
• Use of this product is limited to lifting, holding and
lowering loads consisting of a single mower
compatible with the lift platform. Incompatibility is
evident when the loaded mower wobbles, appears
unstable, and/or does not securely engage the
wheel baskets.
• Restraining an incompatible load will not make the
load secure and may cause unexpected loss of
load.
• Do not exceed rated capacity.
• Use only on hard, level surfaces.
• Center load on lift platform.
• Immediately after lifting load, ensure lift mechani-
cal load holding device is engaged.
• Never work on, under or around a load that is not
stable or secure.
• Keep operator's and bystander's head, hands and
feet away from lift arms when raising and lowering.
• No alterations shall be made to this product.
• Only attachments, restraints or adapters supplied
by the manufacturer shall be used.
• Failure to heed these messages may result in
personal injury and/or property damage.
Height
Unlocking
Handle
Casters
3
Wheel Brackets
Height Locking
Lever