Cleaning The Nozzle - Homeright QUICK FINISH Serie Manual De Usario

CLEANUP (CONTINUED)

CLEANING THE NOZZLE

1.
Make sure power cord is unplugged.
Push the tab below the trigger, twist and separate the nozzle
from the turbine. Wipe the exterior of the cup and nozzle until
clean.
2.
Unscrew the nut and remove the air cap and nozzle.
3.
Remove the parts as shown*. Clean all parts with a cleaning
brush and the appropriate cleaning solution.
Reassemble when clean**.
4.
Clean the rear of the nozzle (d) with the appropriate cleaning
solution. Use a thin layer of petroleum jelly to lubricate the
O-ring (e).
*
The nozzle seal may become
stuck inside the nozzle when the
nozzle is removed. If this occurs,
make sure to pull it out.
ENGLISH
3
**
It is important that the nozzle seal
inside the nozzle be re-installed
properly. Make sure the cup
side of the seal (the side with
the groove) is facing out towards
the front of the nozzle. Improper
installation will cause leakage and
damage to the turbine.
10
1
2
4
Groove
e
d