Parts List - Homak RD00920250 Guía De Utilización Y Directivas De Funcionamiento

INSTRUCTIONS:
1. Before assembling, please check the parts quantity according to
the PARTS LIST.
2. Carefully unpack and spread out all parts in a large uncluttered area.
3. Familiarize yourself with all parts and compare them with the drawing below to
make sure none are missing.

PARTS LIST:

A) Cabinet Body
B) 3 Protective Window Covers
C) Hardware Box:
a) Abrasive Gun
1) Gun
2) Small Hose
3) Large Hose
4) Ceramic Nozzle
5) Compressor Nozzle
6) 2 Washers
b) 2 Plugs
c) Sealing Tape
d) Power Cord
e) 3 Ceramic Nozzles
f) Siphon Pipe
g) Intake Filter
This unit comes with 3 replacement Window Covers (Part B). The Window Cover is made
out of 0.5 mm PVC film. If the film is getting unclear, it may be replaced to avoid affecting
visibility during work.
ASSEMBLY
1. Slide Siphon Pipe (Part f) into position on the bottom of the cabinet.
2. Before use, remove plug on the back of the unit, and install the Intake Vent (Part g).
NEVER USE THE ABRASIVE CABINET WITH THE HOLE PLUGGED.
ASSEMBLE ABRASIVE GUN
1. Unscrew Compressor Nozzle (Part 5) and remove the 2 Large Washers (Part 6) from the
Small Hose (Part 2)
2. Wrap Sealing Tape (Part c) several times around the exposed threads and reinstall one
Large Washer (Part 6)
3. Feed exposed thread through the hole in the lower right side of the cabinet. Reinstall
other Large Washer (Part 6) and screw on Compressor Nozzle (Part 5). DO NOT OVER
TIGHTEN.
4. Loosen screw at the end of Large Hose (Part 3). Slide Large Hose over the smaller end
of Siphon Pipe (Part f) and retighten screw.
A
C
a.
f.
- 3 -
B
b. c. d.
g.
e.