Brinly FB-42RY El Manual Del Propietario página 13

================================================================================================
Assembly Step 12
Joining the Push Arm to the Blade
4. Attach spring trip bracket (18) using:
- 1 Hex Head Bolt (29) – 3/8" x 1 1/4"
x
- 1 Washer, Flat (34) – 3/8"
x
- 1 Lock Nut (41) – 3/8"
x
9/16" Wrench & Socket
DO NOT tighten completely (yet).
Assembly Step 13
Joining the Push Arm to the Blade
5. Mount trip spring by treading 3/8" x 2 1/2" full
threaded bolt (46) and 3/8" washer (34) so that the
head of the bolt is captured
inside of spring (15).
6. Hook the opposite
end of the spring
(15) through the
pivot weldment (8).
7. Insert the bolt through
the trip bracket (18) that
was installed on Assembly
Step 12.
Tread and tighten the 3/8"
toothed nut (44) until the
spring is touching the
bracket.
9/16" Wrench & Socket
8. Tighten the nut and bolt that were added
on Assembly Step 12.
**Exterior circumference of washers can vary.
These dimensions are a measurement of the
internal diameter of the washer.
ASSEMBLY
18
41
34
13
34
29
46
44
18
15
8
1/2"
3/8"
5/16"
1/4"
5"
4"
3"
2"
1"
0"
1018348-B