HoMedics enviraScape WFL-PGD Manual De Instrucciones E Información De Garantía página 4

Maintenance
• T o clean the pump:
Unplug from electrical outlet. Remove it from the base of the
fountain. Use a small brush or stream of water to remove any
debris (Fig 4).
• To keep water clean:
Periodically change water and clean the product according to
the water condition. Keeping the water clean prevents the water
from becoming sticky and forming micro-organisms. We recom-
mend distilled water to prevent mineral build-up.
• To clean off hard water deposits on the base:
Soak the container in a mixture of vinegar and water to clean
and remove any mineral build-up.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to
avoid shortening the life of the pump.
NOTE: Never let the pump run dry, as this will shorten the life of
the pump.
-
• Fountain storage
Unplug the fountain from the electrical outlet, empty the water,
+
and store rocks and fountain in a dry, cool place.
Figure 4
PVC Tubing
Inserts Here
Impeller
Pump Inlet
Front Plate
Flow Control
Lever
6
Back Plate
Housing
Suction Feet
Troubleshooting
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure
the pump is getting electrical power.
NOTE: Always disconnect from electrical outlet before han-
dling the pump.
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump has enough
water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the rate of
evaporation; refill with water as needed.
• If water is splashing outside the fountain:
Rearrange the rocks by moving them to the area in the base
where they can be hit directly by falling water.
7