Initial Setup; Operating Modes - Klip Xtreme ZounDtastik mini Manual De Instrucciones

2. Light switch: Turns the LED lights on and off. Make sure to turn on the LED lights only after the unit is fully
powered.
3. Auxiliary input: Connect a CD player, digital media player or other audio source to these stereo line-in
connectors.
4. AC input: Plug the supplied power cable in this jack.
5. FM antenna: Picks up the signal for the tuner.
Remote control
In addition to the panel controls, a remote control is included which provides additional functions to allow greater
control over the media player.
• Install the batteries in the remote control following the correct polarity as indicated inside the compartment.
(Requires two AAA batteries).
•
In order for the remote to operate properly, ensure that it is pointed toward the front of the speaker.
1
2
3
4
5
6
7
8
Control
Cancels the audio coming from the speaker. Press it again to unmute the
1. Mute button
speaker in all modes.
In USB/SD , press this button briefly to play the previous track. Press and hold this
TM
2.
button to fast backward tracks on your playlist
In FM and Bluetooth
This feature is not available in auxiliary mode
Press this button to cycle through the different audio sources: Bluetooth
3. Mode
Line In and FM.
4. REC button
To start recording, simply press this button once. Press it again to stop the recording
and back to the previous function. During audio playback, briefly press this button to
delete the recorded file. DEL will come up on the screen to confirm this action.
5. Light
Turns the LED lights on or off
6. Bass +/- Increases or decreases the bass (low) frequencies of the speaker
Scrolls through the different sound effects: classical, pop, rock, jazz, normal
7. Equalizer EQ
8. Mic volume Increases or decreases the audio level of the microphone
9. STANDBY Press this button to toggle the device from standby to active mode, and vice versa.
STANDBY
9
10
11
12
13
MODE VOICE REPEAT
14
15
REC REC PLAY R.DEL
16
17
LIGHT RGB M-PRI
- -
+ +
18
BASS TREBLE
+ +
EQ
MIC
19
VOL
VOL
- 0 -
1 2 3
20
4 5 6
7 8 9
Description
® modes, press it briefly to go to the previous channel or song.
10.
11.
12. Voice
13. Repeat
14. REC Play
15. R-DEL
16. RGB
17. M-PRI
18. Treble +/-
19. Vol +/-
20. Numbered keypad
IV. Initial setup
Note: For your safety, read this manual and follow all safety instructions before using the product.
Charging the battery
1. Plug the AC cable to a wall outlet.
2. When the unit is not in use or switched off, it will automatically recharge the internal battery as long as it
remains connected to utility power.
Powering on the unit
1. Turn the volume, echo and mic volume controls on the top panel fully counterclockwise.
2. Set the bass and treble equalizer controls to the 12 o'clock position.
3. Turn the power switch to the on position.
Using the wireless microphone
1. Insert AA batteries into the handheld microphone by carefully unscrewing the base of each one and aligning
the "+" and "-" terminals of the batteries with the corresponding contacts inside the compartment.
2. Turn on the microphone. The speaker will detect the device automatically.
3. When not in use, switch the wireless microphone off to conserve battery power.
, USB, SD ,
® TM
V. Operating modes
1. Auxiliary playback
a. Use the supplied audio cable to connect the speaker to external audio devices through the Auxiliary input
located on the back panel.
b. If the speaker is not set to the AUX IN, press the MODE button until the corresponding input mode is
found.
c. When the AUX indicator is displayed on the screen, you can start streaming audio directly from compatible
multimedia sources.
d. Please note that the forward and backward song selection is not available on this mode.
Press to start and pause media during Bluetooth
®
In USB and SD mode, press this button briefly to play the next track. Press and
TM
hold this button to fast forward tracks on your playlist.
In tuner and Bluetooth ® mode, press it briefly to go to the next channel or song.
This feature is not available in Line In mode
Briefly press this button to emphasize the voice. Press one more time to return to
normal voice
In USB and SD modes, use it to repeat a single track or repeat all tracks
TM
Press this button to playback recorded files
Use it to erase recorded files. For this feature to work, the speaker must be set in
recording playing mode first
Changes the LED light color between green, red and blue. Press Light to reset to
normal
It gives priority to the microphone voice. It will only work with a wired microphone
connected to the jack
Increases or decreases the treble (high) frequencies of the speaker
Increases or decreases the volume level of the speaker
In USB and SD TM modes, press any key from 0 to 9 on the remote to choose directly
the tracks you want to play
, SD or USB playback
TM