Publicidad
6. Disconnect the battery wires from the terminals. Be sure to replace the same type of
batteries and dispose of old batteries properly at an appropriate recycling facility.
7. Install the replacement battery by connecting the red wire and black wire to the positive
(+) and negative (-) terminals of the battery. It is normal to see small sparks upon
connecting the red/black wires on the positive (+)/ negative (-) terminals of the battery
when replacing it.
9. Technical speci cations
MPN
Capacity
Nominal voltage
Input
Voltage range
Frequency
AC plug style
Nominal voltage
Frequency
Frequency stability
Waveform
Total outlets
Output
Full battery / Surge
protection outlets
Surge protection outlets
only
Network protection
Phone/modem/fax
protection
Sat/Cable protection
USB charger
Battery type and quantity
Battery
Backup time
Recharge time
Battery replacement
design
High cut off
Voltage regulation
Boost
Buck
Low cut off
Automatic frequency
Frequency regulation
selection
Typical transfer time
Low line transfer to
Line/Battery transfer
battery
line
High line transfer to
battery
Visual indicators
Audible
Alarms/Indicators
Full protection
Protection
Joules
"Cold start" option
Special features
Auto charge
Operating temperature
Environment
Storage temperature
Relative humidity
Audible noise
Physical appearance
Housing
Dimensions
Weight
Additional information
Warranty
8. Put the battery back into the compartment.
9. Slide the cover of the battery compartment until it locks in place and replace the screw.
10. The new battery must be charged for at least 6 hours to its full capacity.
HT-752LCD
HT-1002LCD
750VA/375W
1000VA/500W
220V
162-268VAC
45-65Hz (autosensing)
NEMA 5-15P
220V +/- 10%
50/60Hz
+/- 1Hz battery mode
Modified sine wave
10 Universal NEMA
5
5
RJ-45
RJ-11
Included
2.1A max (2)
12V/7Ah (1)
12V/9Ah (1)
25 min.**
32 min.**
4 hours to 90% after complete discharge
Yes
268V
198V
242V
162V
Included
2-4ms
162VAC
268VAC
Easy to read LCD with a blue backlight that displays the input voltage, output
voltage, battery capacity, load level, and UPS status
Battery mode: Beeps once every 10 seconds
Low battery: Beeps once every second
Overload: Beeps once every 0.5 second
Fault: Continuous beep
Voltage regulation, overload, discharge and overcharge protection
510J
Included
Included
32-104°F
-4-122°F
0-90% non-condensing
<40dB at one meter
Fire retardant plastic
13.2x7.9x4.5in
13.9lb
14.3lb
3 years*
*2 years on batteries
**Calculated with a single PC plus monitor
Publicidad
