Federal Communications Commission Radio Frequency Interference Statement - Lanix LT1 Manual De Usuario

Avisos
Federal Communications Commission Radio Frequency
Interference Statement
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instruction manual may cause harmful in-
terference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
● Consult the dealer or an experienced radio TV technician for
help.
NOTICE:
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. Shielded interface cables and a non-shielded CA power cord
must be used in order to comply with emission limits. This equipment is to be used with power supply:
40W There is no internal power supply.
Canadian DOC Notice For Class B Computing Devices
This Class B digital apparatus meets all requirements of the Canadian Interference - Causing Equipment
Regulations.
Cet appareil numerique de la classe B repecte toutes les exigences du Règlement sur le matèriel broui-
lleur du Canada.
Manual de Operación
4