Problem Solution - Work WX152 Manual Original

OPERATION
Forward/reverse rotation control
WARNING: Never
change the direction
of rotation when the chuck
is rotating, wait until it has
stopped!
TWO-SPEED GEAR
CONTROL
TORQUE ADJUSTMENT
DRILLING, SCREWDRIVING
Operating the on/off switch
WARNING: Do not
operate for long
periods at low speed
because excess heat will be
produced internally.
LED Light Indicator
Before operation, the LED light will be activated
when the On/Off switch is slightly depressed.
The tool and battery are equipped with a
protection system. When the LED Light is
quickly flashing 60 seconds and turn off, the
system will automatically cut off power to
the tool to extend battery life. The tool will
automatically stop during operation if the tool
and/or battery are placed under one of the
following conditions:
• Overloaded: The tool is operated in a manner
that causes it to draw an abnormally high current.
In this situation, release the Trigger Switch on
the tool and stop the application that caused the
tool to become overloaded. Then pull the Trigger
Switch again to restart.
• Overheated: Under the condition above, if
the tool does not start, the Tool and Battery are
overheated. In this situation, let the Tool and Battery
cool before pulling the Trigger Switch again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool will not
operate. In this situation, remove and recharge
the Battery.
WARNING: To turn on the light, press
the On/Off switch and make sure the
Forward/Reverse Rotation Control is on
right/left position.
Lithium-Ion Cordless Drill/Driver

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is
See Fig.
on top of the trigger, is positioned in the lock
C1, C2, C3
function. Unlock the forward/reverse rotation
control by putting it into the required rotation
position. Push the trigger and the drill will
start to rotate.
See Fig. D
2. THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
See Fig. E
Verify the torque position of the torque
adjusting ring, you can find the
torque-adjusting ring between the chuck and
the drill body. Position 1 is the lowest torque
(screw driving force) and position 15 is the
See Fig. F
highest torque (screw driving force). Position
is for drill operation. Regulate the torque
adjusting ring to a higher position to reach the
best result.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a battery pack for a prolonged
time will reduce the battery pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0°C and above 45°C as this will affect
performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
11
EN