Installation Instructions
If replacing an older faucet ensure water supply
Caution:
is turned OFF before removing. Then open faucet valves to
relieve water pressure.
Step 1 Attach control valves to sink
■ Thread flange nut about
inches down away
2
from end of valve body.
■ Insert valve body from
under sink up through
mounting hole.
Ensure valve with
red striped hose (hot)
is on the left and blue
(cold) is on the right.
■ Place gasket over valve
body and then thread
fastener onto valve body
down to about
inch.
3/4
■ Thread collar onto valve body until stop is reached and
then thread fastener back up against collar until hand tight.
■ Tighten flange nut and mounting washer under sink and
secure with mounting screws if necessary.
Step 2 Attach faucet handles
■ Turn valve spindles
to the
position.
OFF
- left valve,
HOT
clockwise
- right valve,
COLD
counter clockwise
■ Attach handle to
valve spindle in
OFF
location as shown
and fasten with
Phillips head screw.
Step 3 Attach faucet spout to sink
■ Unscrew tee and remove
washer and nut from
threaded end of
spout as shipped.
■ Insert end of spout
down through
mounting hole in
sink and then fasten
from under sink
with washer and nut.
washer
■ Tighten nut while
ensuring spout
is centered over
mounting hole and
flat edge of washer is facing rear of sink.
collar
fastener
gasket
valve body
mounting washer
ange nut
mounting screws
screw
handle
valve spindle
spout
nut
tee
Step 4 Connect water supply lines
■ Thread tee onto end of spout.
This may
Note:
require
inches of
4
clearance.
■ Apply pipe sealant
on both flex hose
adapters. Thread
into side of tee.
■ Attach flex hoses to
flex hose adapters.
■ Plumb hot water
supply to left valve
body inlet, cold
water to right inlet
(supply hoses not
included).
■ Check for leaks
if only replacing
faucet and drain is
already installed by first turning faucet handles to the
position and then turn water supply valves
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew
flange and remove flat
rubber washer from end
of drain body as shipped.
■ Apply plumber's putty
around bottom of flange.
Rubber washer
Note:
included should only be
used when plumbers
putty is not available.
■ Move friction washer,
beveled washer and
flange nut down away
from threaded end of
drain body.
■ Place flange into drain
opening and then from
under sink screw drain
body up into flange at least
2-3 turns until hand tight.
■ Position drain body so pivot cavity is facing rear of sink and
then slide beveled washer and friction washer up against sink.
■ Tighten flange nut up against friction washer to evenly
compress beveled washer while also ensuring flange is
centered in drain opening.
Take care not to over tighten flange nut.
Page 2
valve
outlet
inlet
&
ex hose
adapter
tee
ex hose
.
ON
PLUMBERS
PUTTY
ange nut
drain body
spout
valve
body
OFF
ange
beveled
washer
friction
washer
pivot
cavity