Commencing Operation; Instructions For Assembly - Bona Belt Manual De Funcionamento

Commencing Operation

Instructions for assembly

Assembly an new Machine
1.
Push together the handle
shaft with the shaft holder.
4.
Lift the control lever to the
uppermost position.
If the machine has been disassembled before transport then assemble the motor as follows:
1) Grab hold of the motor's carry handle. Place the motor on
the machine frame and fasten the motor's hinge in the rear
holder.
2) Roll on and tighten the driving belt using the eccentric
tightener. Lift up the belt protector. Mount the dust pipe with
the dust bag in the pipe holder.
8 8
2.
Screw and tighten locking wheel
5.
Push down the dust pipe in the
pipe holder.
Excessive belt tension may cause the
premature failure of the ball bearings.
Using the machine when not fully assembled may cause injury
or damage to people or objects. DO NOT use the machine when
it is not fully assembled. Keep all fittings tightly closed. Maintain
machine settings in accordance with the specifications.
Bona Belt Manual
3.
Put together the upper and lower
control rod and pass the sliding
sleeve over the lower control rod.
6.
Then affix a dust
bag to the dust pipe.