Bifinett KH 1130 Instrucciones Para El Manejo Y La Seguridad página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
remove any remaining dough or flour from the side and
edge of the bowl.
3.
When you wish to remove the contents of the bowl, first
switch off the Handmixer. Then press the support release
button
, fold the support
mixing bowl
from the stand
4.
Press the unlocking button
and then press ejection button
beater blades
or kneading rods.
Use of the blending rod
Preparation
1.
You will find the insert position for the blending rod at
the back of the Handmixer
reasons. Before attaching the blending rod you must first
open the safety device
2.
Press the rod in until this locks into position and then twist
until secure.
Blending
1.
The blending rod
is operated exclusively with the turbo
button
(see Chapter "Speed settings"). Hold the turbo
button
down during use. As soon as you release this
button the motor will stop.
2.
In order to prevent overflowing, ensure that the blending
vessel is never more than
of approx. 18 cm in height and with a diameter of approx.
11 cm.
upwards and take the
.
to remove the Handmixer
in order to release the
. This is covered for safety
.
2
full. We recommend a vessel
3
3.
To ensure that ingredients get ideally mixed, the material
to be blended must cover at least the bottom section of
the blending rod.
4.
Do not switch on the mixer until you have lowered the
rod into the material to be blended.
5.
Never use the blending rod for hard materials, such as
coffee beans, ice cubes, sugar, cereals, chocolate, raw
potatoes, etc.
6.
When you are finished using the Handmixer, return the
speed control
to the "0" position and disconnect the
plug.
7.
To clean the blending rod screw out of the inset position .
The enclosed fixing clip can be used for holding the power
cable.
Caution!
1.
Always allow the Handmixer to rest for a few minutes
after every 5 minutes of constant use – in particular after
using the blending rod
2.
Never keep the appliance in constant operation for more
than 10 minutes!
3.
Never dip the blending rod
Clean only the bottom part with knife under flowing
water.
.
into water.
11
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido