Installing Projector Mount Assembly - peerless-AV PSTA-600 Instalación Y Ensamblaje

Installing Projector Mount Assembly

Follow steps detailed in instruction manual included with PRS-UNV for installation of projector mount assembly to
3
projector.
Install projector mount assembly onto threaded tube with at least three turns as shown in fi gure 4.1. Tighten
4
swivel stop screw as shown in detail 1 using 4mm security allen wrench (supplied with PRS-UNV). NOTE: Do not
overtighten screw. Overtightening screw will damage threads making it diffi cult to separate products.
Slide connection block with projector into projector mount assembly as shown in fi gure 4.2. Push in and fully tighten
captive screw to secure projector to projector mount assembly. Adjust wall arm assembly (AA) to desired projector
throw distance.
For security installations, insert one #10-32 x 1/4" socket pin screw (supplied with PRS-UNV) through projector
mount assembly and into connection block as shown in fi gure 4.3. Tighten screw with 4mm security allen wrench.
AA
Fig. 4.2
CAPTIVE
SCREW
Fig. 4.1
THREADED TUBE
ARROW INDICATES
FRONT OF MOUNT
CONNECTION BLOCK
5 of 21
SWIVEL STOP
SCREW
DETAIL 1
Fig. 4.3
#10-32 X 1/4"
SOCKET PIN SCREW
ISSUED: 05-02-11 SHEET #: 056-9036-3 08-25-11