Amann Girrbach electronicsteamer II Modo De Empleo página 7

IMPORTANT
The safety cap (9) is fitted with a pressure relief
valve which opens automatically if a pressure of 6
bar is reached. Normally, however, the electrically
controlled and monitored heater will cut out before
the pressure gauge drops into the red area. If the
pressure gauge needle nevertheless shows red,
switch off the steamer and disconnect it from the
mains supply. If this happens, the device should be
returned to the manufacturer for inspection as a
safety precaution.
MAINTENANCE
The Electronic Steamer II is basically maintenance-
free. However, it must be descaled at regular inter-
vals. A control lamp (7) and acoustic signal will tell
you that the device needs descaling after about 50
hours of operation.
ATTENTION
The user manual for decalicifying is added to the
delimer. Do not switch on the steamer or use the
steam head during the descaling process. Once the
descaling and flushing operations have been comple-
ted, ensure that the drainage screw (12) on the
underside of the device is screwed tightly shut. Now
press the reset button (13) on the underside of the
device. This will reset the scale monitor.
Do not use cleaning products containing solvents to
clean the outer surfaces of the steamer.
Technical Data:
L/B/H:
Weight:
Mains supply:
E-fuse:
Power:
Steam pressure:
Boiler capacity:
Heating up time:
Accessories/single components:
Order No.
116814 Sieve, small, dia. 50 mm
116815 Sieve, large, dia. 75 mm
116813 Funnel
516330 Clean Steamer
516340 Stymo Net
116811 Kalk-X Liquid
116835 Lid
116340 Sealing kit for the lid
360/270/290 mm
9 kg
230V 50Hz
10 A inert
1430 W
4 bar
4.2 l
approx. 20 min
1168432 O-ring set for drainage screw
1168391 O-ring set for nozzle (HS)
Delivery scope:
Order No.
116810 Electronic Steamer, Funnel
WARNINGS AND
!
SAFETY ASPECTS:
The Electronic Steamer II has been developed for
use in dental applications. The device must be ope-
rated and used in accordance with the manufactur-
er's instructions.
The manufacturer shall accept no liability whatsoe-
ver for damage resulting from inappropriate use or
improper handling.
In the event that the intended applications are not
mentioned in the manufacturer's instructions, the
user shall be responsible for establishing the suita-
bility of the device prior to its use.
• Do not steam clean any live parts or equip-
ment.
• Use tap water or distilled water only.
• When the power is switched on, the device is
under pressure. Never open the filler neck or
drainage screw under these circumstances.
• Never direct the steam jet at people or
animals.
• Always ensure that the power switch is OFF
and there is no pressure left in the steamer
before opening either the safety cap on the
filler neck or the drainage screw.
• Never grasp the nozzle head at the end of
the handpiece when the steamer is ready for
operation – risk of burning.
GB
7