TROUBLESHOOTING
In case of difficulty, review the "Symptom and Remedy" list below.
Make sure no part of the AlertMaster system is on or near metal
surfaces or electrical equipment. Should the difficulty persist,
contact Clarity or your authorized dealer for assistance.
WARNING! DO NOT open the unit. You may be exposed to
hazardous high voltage electricity.
Symptom
LAMP CONTROL button
doesn't work
Phone rings, lamp does not
flash
Doorbell doesn't work
13
Cause and Remedy
Lamp is not turned on prior
to plugging it into AlertMaster.
Replace bulb if necessary.
Check all phone line
connections. Make sure you can
turn the lamp on or off with
the lamp control button on the
AL11 console.
Dead battery. Depress doorbell
button; the red indicator light
should light up. Replace battery
if necessary.
The DIP switches may be
incorrectly set. See section on
"Channel Setting."
It may be out of range. Make
sure doorbell is within range of
80 feet of the AL11 base unit.
OPTIONAL ACCESSORIES
The AlertMaster AL11 is designed to work with optional wireless
remote receivers and transmitters, each sold separately.
A. AlertMaster Remote
Receiver (AL12™)
Flashes a connected lamp to notify
you wherever the receiver is placed,
such as the kitchen, living room,
garage, bathroom, etc., up to 80 feet
from the AlertMaster Model AL11
base console.
B. AlertMaster Personal
Signaler (AMPX™)
Wear this lightweight receiver on
your belt anywhere around your
house within an 80-foot radius
from the AlertMaster Model AL11.
C. AlertMaster Personal Tactile
Signaler (AMPXB™)
Similar to Model AMPX. This
personal receiver is designed to
meet the needs of the deaf-blind.
A touch switch allows each alerting
source to be identified by tactile
indication.
E
N
G
L
I
S
H
14