Fender MH metalhead 500 Instrucciones De Funcionamiento página 2

ENGLISH - PAGES . . . . . . 6-7
FCC Compliance Notice: This equipment has been tested and found to
comply within the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide a reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if
not used in accordance with the instructions, may cause harmful
interference to radio communications and there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
reorient or relocate the receiving antenna, increase the separation between
the equipment and receiver, connect the equipment into an outlet on a
circuit different from that of the receiver. Consult the dealer or an
experienced radio/TV technician if help is needed.
ESPAÑOL - PAGINAS . . . . 8-9
FRANÇAIS - PAGES . . . . . 10-11
ITALIANO - PAGINE . . . . . 12-13
DEUTSCH - SEITEN . . . . . 14-15
PORTUGUÊS - PAGINA . . 16-17
. . . . . . . . . . 18-19
I m p o r t a n t S a f e t y
This symbol warns the user of dangerous voltage levels
localized within the enclosure.
This symbol advises the user to read all accompanying
literature for safe operation of the unit.
∆ Read, retain, and follow all instructions. Heed all warnings.
∆ Only connect the power supply cord to an earth grounded AC
receptacle in accordance with the voltage and frequency ratings
listed under INPUT POWER on the rear panel of this product.
∆ WARNING: To prevent damage, fire or shock hazard, do not
expose this unit to rain or moisture.
∆ Unplug the power supply cord before cleaning the unit exterior
(use a damp cloth only). Wait until the unit is completely dry
before reconnecting it to power.
∆ During operation: Maintain at least 6 inches (15.25 cm) of
unobstructed air space around the unit to allow for proper
ventilation and cooling of the unit; do not block any vents in the
unit chassis. Also, if rack mounted, remove the rack enclosure
front and rear covers and leave empty one full rack space above
the unit.
∆ This product should be located away from heat sources such as
radiators, heat registers, or other products that produce heat.
∆ This product may be equipped with a polarized plug (one blade
wider than the other). This is a safety feature. If you are unable
to insert the plug into the outlet, contact an electrician to replace
your obsolete outlet. Do not defeat the safety purpose of this
plug.
∆ Protect the power supply cord from being pinched or abraded.
∆ This product should only be used with a cart or stand that is
recommended by the manufacturer.
∆ The power supply cord of this product should be unplugged from
the outlet when left unused for a long period of time, or during
electrical storms.
∆ This product should be serviced by qualified service personnel
when: the power supply cord or the plug has been damaged; or
objects have fallen, or liquid has been spilled onto the product;
or the product has been exposed to rain; or the product does not
appear to operate normally or exhibits a marked change in
performance; or the product has been dropped, or the enclosure
damaged.
∆ Do not drip nor splash liquids, nor place liquid filled containers on
the unit.
∆ CAUTION: No user serviceable parts inside, refer servicing to
qualified personnel only.
∆ Fender
® amplifiers and loudspeaker systems are capable of
producing very high sound pressure levels which may cause
temporary or permanent hearing damage.
setting and adjusting volume levels during use.
I n s t r u c t i o n s
Use care when