Publicidad
Idiomas disponibles
Idiomas disponibles
Tools required for assembly:
The following parts are included in the hardware bag (bagged separately):
The only tools required for assembly are
Handle Assembly
11 mm and 18 mm wrenches or sockets.
Handle nuts (4)
Handle bolts (4)
Handle Arch
B
(pointed down)
G
F
Handle Assembly
1. Lay out the handle parts upside down as shown above for easier
assembly. Note the center handle section
(A)
is symmetrical, so it can
be laid down on either side.
2. Make sure the arch of the upper handle section
(B)
is facing down.
Then insert the free ends of the upper handle section
(B)
into the center
handle section (A). Roughly align the holes.
3. Make sure the lower handle sections,
(C)
and (D), are laid out with the
notches up. Then insert the left lower handle section (marked with "L")
and the right lower handle section (marked with "R")
(D)
into the center
handle section
(A)
as shown. Roughly align the holes.
6
Fiskars Help Line: 1-877-201-3260
Rear Wheel Assembly (next page)
Rear wheels (2)
Rear wheel bolts (2)
Rear wheel washers (2)
A
E
4. Slide handle shroud
into place from below with the Fiskars logo facing
(E)
down and toward the upper handle section (B).
5. Align holes in handle sections and shroud (E). Slide a handle bolt
from the inside, so that the end comes through the hole of the handle shroud.
Repeat for the remaining three handle bolts.
6. Align the hex-shaped bolt head with the hex-shaped cutout in the center
handle section (A), then hand-tighten a handle nut
(C)
Repeat for the remaining three handle nuts.
7. Using an 11 mm wrench or socket, tighten the four handle nuts
they are snug.
videos & more at: fiskars.com/reelmowers
Rear Wheel Assembly
1. Assemble the rear wheel bolt
(B)
and insert through the rear wheel (C).
2. Screw the bolt assembly into the swing arm
R
using the 18 mm wrench or socket.
3. Repeat for the other rear wheel.
D
(right)
C
(left)
A
C
L
B
D
(F)
through
(G)
onto the bolt.
(G)
until
Attaching the Handle
(A)
through the rear wheel washer
1. Remove the two cotter pins
2. Slide hole number 2
(D)
and tighten firmly
Some force may be needed to separate the handle legs so they fit over
the pegs. Release the handle until it rests on the handle stop peg (D).
3. Insert the cotter pins
B
C
1
Fiskars Help Line: 1-877-201-3260
(A)
from the handle mount pegs (B).
(C)
of the handle onto the handle mount pegs
(B).
(A)
to secure the handle.
A
3
D
2
B
A
C
D
7
videos & more at: fiskars.com/reelmowers
Publicidad
