Handle Height Adjustment - Fiskars StaySharp Manual De Instrucciones

Cut Height Adjustment
1. Standing to the rear of the mower, place your left hand on the lifting handle
(A) to support the mower during adjustment.
2. Use your right hand to pull the cut height adjustment knob
the mower and move to your desired cut height. Then release the knob,
making sure it snaps back into place.
3. Repeat the process on the other side, reversing hand placement, making
sure both wheels are at the same setting. Failure to align the wheels will result
in an uneven cut.
Note: The factory-set cut height range is 1.5"–3.5".
Low
Bajo
High
Alto
1
2
Low
3
Bajo
High
Alto
1
4
2
3
4
5
6
5 7
03-015272r1
6
A
7
03-015272r1
REPRODUCTION
8
Fiskars Help Line: 1-877-201-3260 Fiskars Help Line: 1-877-201-3260

Handle Height Adjustment

IMPORTANT: To maximize comfort and control, your mower
features a height-adjustable handle. The handle is designed to
(B) away from "float" between its bottom and in-use positions. The bottom position is
used to pivot through turns. The in-use position should be 6"–10" above
the bottom position. Lifting the handle in this fashion keeps the front
end from rising off the ground to ensure an even cut. Since selecting
the correct handle height is extremely important, it is worth the
trial and error that may be required to find the ideal height.
1. For people of average height, handle hole 2 can be used for the middle
cut-height settings, which are the most common. If you are tall or plan to
use the lower cut height settings, consider using hole 3. If you are short or
plan to use the higher cut height settings, consider using hole 1.
2. Before adjusting the handle height, it is important to set the mower to the
cut height that you will use most frequently (see Cut Height Adjustment ).
3. Push the mower forward several feet, then turn it around as you would at
the end of a mowing run. If you can push the mower comfortably without the
front end rising and if you can turn the mower without hunching over, you
have the handle set properly.
Low
Bajo
High
Alto • If the front end rises, you have the handle set too high. Lower the
1
2
3
4
handle by using hole 1.
5
B
6
7
03-015271r1
• If you have to hunch over a great deal to turn, you have the handle set
too low. Raise the handle by using hole 3.
3. As the cut height is adjusted, the handle's bottom position will also move.
Consequently, you may need to adjust the handle height if you drastically
change the cut height. Adjustment may also be needed if you share
mowing duties with someone else.
videos & more at: fiskars.com/reelmowers videos & more at: fiskars.com/reelmowers
In-use position
6" to 10" Float
Bottom position
Fiskars Help Line: 1-877-201-3260 videos & more at: fiskars.com/reelmowers
9