fireStorm FS210LS Manual De Instrucciones página 22

Common sawing operations include ripping and crosscutting plus a few other standard operations of a fundamental
nature. As with all power machines, there is a certain amount of hazard involved with the operation and use of the
machine. Using the machine with the respect and caution demanded as far as safety precautions are concerned, will
considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or
completely ignored, personal injury to the operator can result. The following information describes the safe and proper
method for performing the most common sawing operations.
THE USE OF ATTACHMENTS AND ACCESSORIES NOT RECOMMENDED MAY RESULT IN THE
RISK OF INJURY TO THE USER OR OTHERS.
CROSS-CUTTING
Cross-cutting requires the use of the miter gage to
position and guide the work. Place the work against the
miter gage and advance both the gage and work toward
the saw blade, as shown in Fig. 46. The miter gage may
be used in either table slot. When bevel cutting (blade
tilted), use the table groove that does not cause
interference of your hand or miter gage with the saw
blade guard.
Start the cut slowly and hold the work firmly against the
miter gage and the table. One of the rules in running a
saw is that you never hang onto or touch a free piece of
work. Hold the supported piece, not the free piece that
is cut off. The feed in cross-cutting continues until the
work is cut in two, and the miter gage and work are
pulled back to the starting point. Before pulling the work
back, it is good practice to give the work a little
sideways shift to move the work slightly away from the
saw blade. Never pick up any short length of free work
from the table while the saw is running. Never touch a
cut-off piece unless it is at least a foot long.
For added safety and convenience the miter gage can
be fitted with an auxiliary wood-facing. This auxiliary
wood-facing can be fastened to the front of the miter
gage by using two wood screws through the slots (A)
Fig. 45, provided in the miter gage body and into the
wood-facing.
NEVER USE THE FENCE AS A CUT-OFF
GAGE WHEN CROSS-CUTTING.
When cross-cutting a number of pieces to the same length,
a block of wood (B) Fig. 46A can be clamped to the fence
and used as a cut-off gage. It is important that this block of
wood always be positioned in front of the saw blade as
shown. Once the cut-off length is determined, secure the
fence and use the miter gage to feed the work into the cut.
This block of wood allows the cut-off piece to move freely
along the table surface without binding between the fence
and the saw blade, thereby lessening the possibility of
kickback and injury to the operator.
WHEN USING THE BLOCK (B) FIG. 46A,
AS A CUT-OFF GAGE, IT IS VERY
IMPORTANT THAT THE REAR END OF THE BLOCK
BE POSITIONED SO THE WORK PIECE IS CLEAR OF
THE BLOCK BEFORE IT CONTACTS THE BLADE.
COMMON SAWING OPERATIONS
22 22
A
Fig. 46
B
Fig. 46A