fireStorm FS210LS Manual De Instrucciones página 23

Tabla de contenido

Publicidad

RIPPING
Ripping is cutting lengthwise through a board. The rip
fence (A) Fig. 47 is used to position and guide the work.
One edge of the work rides against the rip fence while
the flat side of the board rests on the table. Since the
work is pushed along the fence, it must have a straight
edge and make solid contact with the table. The saw
blade guard must be used. The guard has anti-kickback
fingers to prevent kickback and a splitter to prevent the
wood kerf from closing and binding the blade.
1. Start the motor and advance the work holding it down
and against the fence. Never stand in the line of the saw
cut when ripping. Hold the work with both hands and
push it along the fence and into the saw blade (Fig. 48).
The work can then be fed through the saw blade with
one or two hands. After the work is beyond the saw
blade and anti-kickback fingers, the hand is removed
from the work. When this is done the work will either
stay on the table, tilt up slightly and be caught by the
end of the rear guard, or slide off the table to the floor.
Alternately, the feed can continue to the end of the table,
after which the work is lifted and brought along the
outside edge of the fence. The cut-off stock remains on
the table and is not touched until the saw blade has
stopped, unless it is a large piece allowing safe removal.
When ripping boards longer than three feet, it is
recommended that outfeed support (B) Fig. 47, should
be extended as far out as possible to keep workpiece
from falling off the saw table.
2. If the ripped work is less than 4 inches wide, a push
stick should always be used to complete the feed, as
shown in Fig. 49. The push stick can easily be made from
scrap
material
as
"CONSTRUCTING A PUSH STICK."
3. Ripping narrow pieces can be dangerous if not done
carefully. Narrow pieces usually cannot be cut with the
guard in position. If the workpiece is short enough, use a
pushboard. When ripping material under 2 inches in
width, a flat pushboard is a valuable accessory since
ordinary type sticks may interfere with the blade guard.
When using a pushboard, the width of the pushboard
must be added to the width of the rip fence position
setting. A flat pushboard can be constructed as shown in
Fig. 50 and should be used as shown in Fig. 48
NOTE: Some special operations require the addition of
an auxiliary wood facing to the fence, as explained in the
section "USING AUXILIARY WOOD FACING ON THE
RIP FENCE" and use of a push stick.
explained
in
the
section
B
23
A
Fig. 47
Fig. 48
Fig. 49
Fig. 50

Publicidad

Tabla de contenido
loading

Tabla de contenido