Rocol Easyline Edge Manual Del Usuario página 5

www.easylineedge.com
C: (Tip: front wheels should be at their widest setting, adjust width by rotating the thumb
wheel upwards.
04. D & E: Check the airflow by turning the applicator on and feel for airflow at the bottom of the
front wheels. Turn applicator off again.
05. F: Fitting the handle – with handle facing over the rear wheels, gently slide down over the
dark grey battery housing unit until locked into position, you should hear a locking noise.
06. G & H: Setting the height of the aerosol can – the aerosol can may be set at 50mm / 75mm
/ 100mm, simply adjust by pressing down with 2 fingers on the yellow push button and push
up or down until it locks to the desired height.
07. I: Set the width of the line to 50mm, 75mm or 100mm, by rotating the thumb wheel to
required width as shown on the label.
08. J & K: Extending the handle – using one hand to press on both yellow buttons located at
the bottom on the handle, the other hand pulls the handle upwards until it engages with the
locking mechanism.
09. L: Set the handle position by pushing in on the yellow wheel at the bottom of the grey
handle shaft, and turn in a clock-wise direction to unlock. Choose your position. Then, lock
in place by turning the wheel in an anti clock-wise direction.
10. M: Take the aerosol can and shake until metal balls rattle, then shake for a further 60
seconds.
11. N: You must fit the aerosol can with a yellow actuator nozzle. Holding the can upright and
pointing away from you, place the nozzle onto the valve stem and spray upwards.
12. O: Place the aerosol can in the applicator. While sliding into place, twist the can until it
engages with the lock and is held
13. You are now ready to switch the airflow on in readiness for line marking.
14. P: Painting the line – hold handle firmly and press yellow trigger button.
15. Walk at a steady speed. Your speed should be adjusted according to the thickness of the
line required.
16. Q: We recommend that you open the rear legs to their maximum width, unless you are
painting a line close to a wall.
Professional Hints and Tips
Remember...
Once paint dries, clean the applicator masking discs.
•
Rest the applicator over a piece of card when not in use.
•
On very new tarmac/asphalt surfaces apply a quick line as a primer to avoid asphalt bleed.
•
Do not paint on moss, surface frost or morning dew.
•
On rough or artificial surfaces, apply a coat of paint in both directions.
•
Do not mark out car parking spaces when the car park is in use.
•
To draw curves, simply lock the handle and lift the rear wheels of the ground.
•
For further hints and tips please visit www.easylineedge.com
5