JENN-AIR RANGE HOOD JXT5830 Guía De Uso, Cuidado E Instalación página 8

MOUNTING THE RANGEHOOD
1. This range hood is mounted under a
kitchen cabinet unit.
2. Select preferred duct location on rear or
top of unit. For ductless conversion, no
ducting is required, however front cover
panel must be removed prior to installation.
(See page 7)
3. An optional spacer plate is provided to
cover the gap between the back of the
hood and the wall. If using this plate, screw
it onto the hood prior to installation.
4. Begin installation by temporarily removing
the mesh filter panels.
5. Unscrew the two interior side panels and
slide them sideways to allow access for
marking the mounting hole locations.
(See page 7)
6. Temporarily position the range hood in the
desired mounting location.
7. Mark the mounting holes, duct and
electrical access locations with a pencil.
For ductless conversion, no hole is required
for a duct.
8. Drill/cut out the required openings for duct
and electrical access.
9. Install duct work and electrical.
10. Fasten mounting screws into
underside of mounting location,
and reposition hood into place.
11. Hang hood onto mounting screws and
hand tighten.
INSTALLATION
6