Original Ancillaries / And Accessories; Switching On And Off; Setting The Oscillation Speed; Attaching A Sanding Sheet - Parkside PSS 250 A1 Traducción Del Manual De Instrucciones Original

Ocultar thumbs Ver también para PSS 250 A1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General safety advice for electrical power tools / Operation
Never support your hands next to or
in front of the device or on the surface
being worked as there is a risk of in-
jury in the event of slipping.
Always switch off the appliance and
allow the sanding sheet
a stop before setting down the oscil-
lating sander.
Always pull the power plug out of the
socket for all work pauses, before any
work on the appliance (e.g. changing
the sanding paper) and when not in use.
The appliance must always be kept
clean, dry and free of oil or lubricat-
ing greases.
original ancillaries / and
accessories
only use accessories and tools that
are specified in the operating instruc-
tions. The use of tools and accessories other
than those recommended in the operating in-
structions could lead to an increased risk of
personal injury for you.
operation

Switching on and off

Switching on intermittent function:
Press the ON / OFF switch
Switching off intermittent function:
Release the ON / OFF switch
Switching on continuous operation :
Press the ON / OFF switch
and press the locking button
Switching off continuous operation:
Press the ON / OFF switch
again.
20 GB
You can set the desired oscillation speed as needed
with the oscillation speed selector
The required oscillation speed depends on the ma-
to come to
terial being worked and can be determined through
9
practical tests.
appliance, always disconnect the power.
NoTE: Before attaching a new sanding sheet
remove dust and dirt from the sanding plate
Sanding sheets with hook and loop
fastening:
Sanding sheets without hook and loop
fastening:
Various materials require different grit values. You
.
can read which grit value is best suited for which
1
work in our recommendations under "Instructions,
tips and tricks".
.
1
, hold it pressed
1
.
2
then release it
collection box
1
cleaner via an external suction adapter! Under cer-
tain conditions the sanding dust in the dust box (or
in the vacuum's dust bag) may self-ignite, e.g. as a
result of flying sparks generated when abrading

Setting the oscillation speed

Attaching a sanding sheet

Before performing work on the
Fix one side of the sanding sheet
one side of the backing plate
Then attach the sanding sheet
ing plate
and press it firmly into place.
8
Open the two clamping levers
Push one end of the sanding sheet
the open clamping bar
sheet firmly in place by locking the clamping
lever
back in place.
7
Repeat this procedure at the other end.

Vacuuming dust

A risk of fire exists when working with
electrical appliances that have a dust
or can be attached to a vacuum
4
.
10
,
9
.
8
flush with
9
.
8
to the back-
9
.
7
under
9
and clamp the
6
FIRE HAzARD!

Publicidad

Tabla de contenido
loading

Tabla de contenido