Sleep Mode; Replacing Batteries - RISCO Group Panda RW332KP Manual De Instrucciones

Key Function
Off
Slow Flash
On
Off
On
Off
On
Slow Flash
Off
Proximity Tag Operation
Present the RFID (Proximity Tag) to the keypad as shown in the following illustrations:
Note: Before using the Proximity Tag, wake up the keypad by pressing any button on the keypad.

SLEEP MODE

For extending the battery life of the keypad, the keypad is designed with a Sleep mode
function. By default, 10 seconds after the last key has been pressed, the keypad will
turn off its display and LEDs. The time can be configured by your installer to a
maximum of 60 seconds.

REPLACING BATTERIES

1. Remove the fastening screw that secures the mounting bracket to the keypad
(see Figure 1).
2. Slide the keypad and remove it from the mounting bracket.
3. Remove the battery compartment cover.
4. Disconnect the battery cable from the battery connector.
5. Replace the batteries while paying attention to the polarity of the batteries.
System is not ready to be armed
System ready to be armed while Exit/Entry zone is open
System Trouble
System is operating normally
Tamper in the system
No tamper in the system
System connected to cloud
Cloud connectivity trouble
No cloud connection configured
8