Stopping the alarm/snooze function
• If the alarm is triggered, the alarm symbol
• Press the ALARM button (9) to stop the alarm. Otherwise, it will stop automatically after 4 minutes.
Note - Snooze function
While the alarm signal is sounding, press the LIGHT-SNOOZE button (1) to activate the snooze function.
The alarm symbol (7)
after which it will sound again.
5.5. Dual Time settings and display
• Dual Time allows you to set and display a second, completely independent time (8).
• Press the MODE button (11) repeatedly until DUAL TIME is displayed.
• Press and hold the MODE button (11) for approximately 3 seconds. The hours display begins to ash.
• Press the ▲ button (13) or the
MODE button (11). The minutes display begins to ash.
• Repeat the process to set the minutes.
• To select the individual values, press the ▲ button (13) or the
pressing the MODE button (11).
5.6. Backlight
If you press the LIGHT-SNOOZE button (1), the display will light up for approx. 5 seconds.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
8. Technical Data
RC 200 radio-controlled alarm clock
Power supply
Measuring range
Z
Z
/
and
will begin to ash. The alarm signal will be stopped for 4 minutes,
1
2
button (12) to select the hour and con rm your selection by pressing the
Temperature
/
will begin to ash and an alarm will sound.
1
2
button (12) and con rm each selection by
3.0 V
2 x AAA batteries
0°C – +50°C
32°F – 122°F
a
7