Decorative Trimming; Tips For Best Trimming Results - Troy-Bilt TB-50 Manual Del Operador

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

For best results, tap the bump knob on bare ground or

hard soil. If you attempt a line release in tall grass, the

motor may stop. Always keep the trimming line fully

extended. Line release becomes more difficult when the

cutting line gets shorter.

NOTE: Do not rest the Bump Head™ on the ground

while the unit is running.

CAUTION:

assembly. Excessive line length will make the

motor overheat. This may lead to serious

personal injury or damage to the unit.

Some line breakage will occur from:

•

Entanglement with foreign matter

•

Normal line fatigue

•

Attempting to cut thick, stalky weeds

•

Forcing the line into objects such as walls or fence

posts

TIPS FOR BEST TRIMMING RESULTS

• Keep the cutting attachment parallel to the ground.

• Do not force the cutting attachment. Allow the tip of the

line to do the cutting, especially along walls. Cutting with

more than the tip will reduce cutting efficiency and may

overload the motor.

• Cut grass over 8 inches (200 mm) by working from top

to bottom in small increments to avoid premature line

wear or motor drag.

OPERATING INSTRUCTIONS

Do not remove or alter

the line cutting blade

Fig. 9

• Cut from right to left whenever possible. Cutting to the left

improves the unit's cutting efficiency. Clippings are

thrown away from the operator.

• Slowly move the trimmer into and out of the cutting

area at the desired height. Move either in a forward-

backward or side-to-side motion. Cutting shorter

lengths produces the best results.

• Trim only when grass and weeds are dry.

• The life of your cutting line is dependent upon:

• Following the trimming techniques previously explained

• What vegetation is cut

• Where vegetation is cut

For example, the line will wear faster when trimming against

a foundation wall as opposed to trimming around a tree.