Stanley PIUSB2S Manual De Instruccion página 4

• Do not use with positive ground electrical systems.*
*The majority of modern automobiles, RVs and trucks are negative ground.
• Reverse polarity connection will result in a blown fuse and may cause
permanent damage to the unit and will void warranty.
• Do Not oPEN tHIS UNIt — there are no user-serviceable parts inside.
opening the unit will void manufacturer' s warranty.
• Do not use this unit with medical devices. It is not tested for medical
applications.
• Do not use this unit on a watercraft. It is not qualified for marine
applications.
• Check the unit periodically for wear and tear. Return to manufacturer for
replacement of worn or defective parts immediately.
• Install and operate only as described in this Instruction Manual.
• Read And Understand This Instruction Manual Before Using This
Unit.
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Stanley USB Personal Electronics
Charger. Read this Instruction Manual and follow the instructions
carefully before using this unit.
HOW THIS CHARGER WORKS
Your USB charger is designed to convert 12 Vdc to 5 Vdc. It allows the 12 Vdc in
an automobile to supply 5 Vdc power to operate equipment that is normally
supplied from a USB power source. the charging cable specifically designed for
the electronic device being charged is required. May not work for all electronic
devices. this product is intended for consumer use only.
PIUSB2S_ManualENSP_040813.indd 6-7
6
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE:
Mobile Phones
Some mobile phone leads do not allow charging from a standard USB port.
Check with the mobile phone manufacturer before using the phone with this
charger.
Rechargeable Devices
If there is any sign that your appliance is behaving differently when plugged
into this charger than it does when connected to the usual power source,
unplug the appliance and seek advice from the appliance manufacturer.
POWER SOURCE REqUIREMENTS
the power source must provide 12 VDC and must be able to supply the
necessary current to operate the load.
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE:
• the charger must be connected only to batteries with a nominal output
voltage of 12 Volts. the appliance will not operate from a 6 Volt battery and
will sustain permanent damage if connected to a 24 Volt battery.
• Always connect the charger to the 12 volt DC power source before plugging
any devices into the unit.
• Do not attach a USB hub to this unit to allow additional items to be added.
to prevent damage, the unit will shut down if it is overloaded. to restart the
unit you must remove it from the power source, wait for a few seconds and
then re-insert the unit into the power source.
7
5/14/2013 4:18:52 PM