Common Problems; Service Information - Stanley PIUSB2S Manual De Instruccion

3. Avoid locations that are exposed to heating units, radiators, direct
sunlight, or excessive humidity or dampness.
TROUBLESHOOTING

Common Problems

Power/Fault LED Indicator is not lit
• Check that all the DC connections are connected correctly.
• Check the tightness of the DC connection.
Note:
Make sure that your accessory outlet is "live". You may need to turn the
ignition key to the accessory position.
Power/Fault LED Indicator lights red
When the Power/Fault lED Indicator turns from blue (indicating the unit is
powered) to red, a fault condition is present and the unit will automatically
shut down. See the Protective Features Section of this Instruction Manual and
Common Power output Problems in the following section.
Common Power Output Problems
Battery voltage below 11.0 volts
Recharge battery or check DC power supply.
Equipment being operated draws too much power
Reduce load to maximum 10 watts. Although this unit has two outlets, some
devices can draw 10 watts from a single outlet. Connecting another device to
the second outlet in this case would create an overload condition and cause
the charger to shut down.
Charger in thermal shutdown condition
Allow charger to cool down. Ensure there is adequate ventilation around the
load is no more than 10 watts for continuous operation.
PIUSB2S_ManualENSP_040813.indd 10-11
10
ACCESSORIES
Recommended accessories for use with your tool are available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at (877) 571-2391.
WARNING: the use of any accessory not recommended for use with this
appliance could be hazardous.

SERVICE INFORMATION

Whether you need technical advice, repair, or genuine factory replacement
parts, contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
the manufacturer warrants this product against defects in materials and
workmanship for a period of oNE (1) YEAR from the date of retail purchase by
the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the
defective product can be replaced or repaired in the following ways: (1) Return
the product to the manufacturer for repair or replacement at manufacturer' s
option. Proof of purchase may be required by manufacturer. (2) Return
the product to the retailer where product was purchased for an exchange
(provided that the store is a participating retailer). Returns to retailer should
be made within the time period of the retailer' s return policy for exchanges
only (usually 30 to 90 days after the sale). Proof of purchase may be required.
Please check with the retailer for their specific return policy regarding returns
that are beyond the time set for exchanges.
this warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during
11
5/14/2013 4:18:52 PM