Technical Characteristics - CAME DBCT Manual De Instrucciones

GB
"IMPORTANT INSTRUCTIONS FOR SAFE INSTALLATION"
WARNING: IMPROPER INSTALLATION MAY CAUSE SE-
RIOUS DAMAGE. FOLLOW ALL INSTALLATION
INSTRUCTIONS.
THIS MANUAL IS INTENDED ONLY FOR PROFESSIONAL
INSTALLERS OR QUALIFIED PERSONNEL .
Legend
This symbol refers to sections to be read carefully.
This symbol refers to sections concerning safety.
T his symbol refers to notes to be communicated to users.
Reference to Regulations
The following standards have been complied with for the product: EN
12978, UNI EN 954-1, CEI EN 60335-1, UNI EN 12453.
Device Description
Infrared protection device composed of:
- Battery-powered (four batteries) transmitter with dip-switches for
function selection.
Wholly designed and built by CAME Cancelli Automatici S.p.A.
Guaranteed 24 months if not tampered with.
- Degree of protection: IP 54.
- Cordless transmitter for DBS CAME series automation systems
- Maximum distance transmitter/receiver: 10 m

Technical Characteristics

Transmitter
Power: 6 V (four 1.5V AAA batteries)
Absorption: 70 µA
Degree of protection: IP54
Material: PC-ABS UL94V0 / Polycarbonate / TPA1 65 NT Marpram mar
Working temperature:
DBCT
CORDLESS TRANSMITTER
INSTALLATION MANUAL
Dimensions and Hole Measurements
Transmitter
Installation
Before proceeding with the installation, it is necessary to:
• make sure that the mains power is off.
• Check that the product is installed in an area protected from
bumps and that the anchorage surface is solid, and that it is
secured with suitable elements (screws, inserts, etc).
• Install suitable tubes and ducts for electric cable passage to
guarantee protection against mechanical damage
Description/Electric Connections and Dip-Switch
Transmitter
1- Battery lodging
2-Transmission LED indicator
selection dip-switch
3-Connection terminal board
for safety sensitive edges (the
bridge on the terminal board
must be removed if used with
the DBS series.)
n°2
n°1 n°3
K K
K K
K K
ON
1
2 3 4
Functions
+ -
-
K K
K K K K
Dip-switch functions
Dip 1 ON = photo diode 1 is active
Dip 2 ON = photo diode 2 is active
Dip 3 ON = photo diode 3 is active
Dip 4 ON = must be set to ON
1
+
2
3