Care And Maintenance - Portfolio VEL-112-9W-LED Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
3. Attach the black supply wire to the black fixture wire and the white supply wire to the
white fixture wire using wire nuts (BB). Connect the fixture ground wire and the supply
ground wire together using a wire nut (BB). Wrap all wire connections with electrical
tape (not included).
Hardware Used
Wire Nut
BB
4. Make sure wire connections are secure. Carefully position wires and wire nuts (BB)
into the junction box. Attach backplate (B) to crossbar (CC) with screws (DD). Secure
the reflector in place with reflector screws (EE).
Hardware Used
Screw
DD
Reflector screw
EE
IMPORTANT
After mounting the fixture, it will be necessary to apply silicone sealant caulking compound (not included) to the perimeter
of the fixture where the back of the cover plate meets the mounting surface. Silicone caulking prevents water from
entering the junction box.
OPERATING INSTRUCTIONS
Use reflector screws (EE) to adjust the reflector (A) as needed up or down 30°
●
to better achieve the desired light distribution.

CARE AND MAINTENANCE

To clean the outside of the fixture, use a dry or slightly dampened clean cloth to wipe the surface of the fixture.
To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing
the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth to wipe the interior surface of the fixture.
Use clean water. Do not use any cleaners with chemicals, solvents or harsh abrasives.
x 3
x 2
x 2
4
3
BB
4
EE
DD
A
EE
30°
Lowes.com/portfolio